How To Assemble Your Light Kit Glass Shade; How To Assemble Your No Light Cover Plate - Emerson CURVA SKY CF144BS00 Owner's Manual

BP7407-1 44" & 52" Curva Sky
How to Assemble Your
Light Kit Glass Shade
1. Screw in two 50-watt (maximum)
halogen mini candelabra base bulbs in
the light kit plate sockets (Figure 13).
50-WATT (maximum)
HALOGEN MINI
CANDELABRA BASE
BULBS (2)
Figure 13
2. Place the glass shade into the opening
in the fan motor housing assembly,
aligning the three flat areas on the top
edge of the glass with the three raised
dimples on the fan motor housing
assembly and turn the glass shade
clockwise until it stops (Figure 14).
NOTE: periodically check that the glass
shade is seated fully clockwise in the
fan motor housing assembly.
FLAT AREA (3)
Figure 14
8/31/10 4:10 PM
How to Assemble Your
No Light Cover Plate
Do not install any light bulbs into the
light kit plate if using the cover plate.
Installation of light bulbs when using
the cover plate could result in fire,
shock and serious personal injury.
1. Place the cover plate onto the lower
housing aligning the three flat areas on
the top flange of the cover plate with
the three pins on the inside of the fan
motor housing assembly (Figure 15).
LIGHT KIT PLATE
Then turn the cover plate clockwise
SOCKETS (2)
until it stops turning.
2. Your cover plate is now installed
Figure 15
DIMPLES (3)
GLASS
BOWL
9
Page 9
WARNING
!
DO NOT INSTALL LIGHT BULBS
WHEN USING THE COVER PLATE
DIMPLES (3)
FLAT AREA (3)
UL Model No.: CF144 & CF152
COVER
PLATE