Optional Installation Of No-Light Cover Plate - Emerson AIRA ECO CF985BS00 Owner's Manual

9. Optional Installation of No-Light Cover Plate

9.1
If NO light fitter is to be used,
Installation of the No-Light Cover Plate:
Remove the glass bowl from the light fitter by turning the
bowl counter-clockwise. Store glass bowl in a secure place
for future use (Figure 30).
Remove the two 50-watt (maximum) mini-candelabra base
halogen bulbs from
CAUTION: To avoid risk of burns or other injury,
(Figure 30).
assure power is off before attempting to install or
replace the 50-watt (max.) mini-candelabra base
halogen bulbs. Halogen bulbs are very hot and can
cause burns. Allow the bulbs to cool sufficiently
before handling.
CAUTION: Do not touch 50-watt (max.) mini-
candelabra base halogen bulbs with bare hands.
Fingerprints may result in shorter bulb life. Remove
fingerprints with alcohol.
9.2
Place the no-light cover plate into the light fitter, aligning
the three flat areas on the top flange of the no-light cover
plate with the three raised studs in the light fitter. Then turn
the no-light cover plate clockwise until it stops and is
secure (Figure 31).
Proceed to Section 10 to install the wall control.
the light fitter sockets
LIGHT
FITTER
GLASS
BOWL
ROTATE GLASS BOWL COUNTER-CLOCKWISE
TO REMOVE FROM LIGHT FITTER
Figure 30
LIFT NO-LIGHT COVER PLATE
LIGHT FITTER
UP INTO LIGHT FITTER
RAISED STUDS (3)
ROTATE NO-LIGHT COVER PLATE CLOCKWISE TO
ENGAGE ON THE LIGHT FITTER RAISED STUDS
Figure 31
17
REMOVE 50-WATT (max.) MINI-
CANDELABRA BASE HALOGEN
BULBS (2)
FLAT AREA
OF NO-LIGHT
COVER
PLATE (3)
NO-LIGHT
COVER
PLATE
emersonfans.com
Please contact 1-800-654-3545 for further assistance
E.T.L. Model No.: CF985