Lenovo 7D9P Manual page 173

• FQXSFMA0055G: Mirror failover operation was unsuccessful. DIMM [arg1] cannot fail over again.
[arg2]
Severity: Warning
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Reseat the failing DIMM identified by LightPath and/or event log entry
3. Restore A/C power and power on the system.
4. Check Lenovo support site for an applicable service bulletin or firmware update that applies to this
memory error.
5. If the problem persists, collect Service Data logs.
• FQXSFMA0056M: An uncorrected recoverable memory error has been detected on DIMM [arg1] at
address [arg2].[arg3]
Severity: Error
User Action:
1. Power off the system and remove A/C power.
2. Reseat the failing DIMM identified by LightPath and/or event log entry
3. Restore A/C power and power on the system.
4. Check Lenovo support site for an applicable service bulletin or firmware update that applies to this
memory error.
5. If the problem persists, collect Service Data logs.
• FQXSFMA0057G: Page Retire PFA Threshold limit exceeded on DIMM [arg1] at address [arg2].
[arg3] [arg4]
Severity: Warning
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Reseat affected DIMM.
3. Restore A/C power and power on the system.
4. Check Lenovo support site for an applicable service bulletin or firmware update that applies to this
memory error.
5. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFMA0058K: Near Memory/Far Memory ratio (1:[arg1].[arg2]) for CPU high bandwidth cache
mode configuration is not in recommended range (1:[arg3] - 1:[arg4]).
Severity: Warning
User Action:
Complete the following steps:
1. Validate system's memory configuration by using the memory configuration tool below: https://dcsc.
lenovo.com/#/memory_configuration.
2. Resolve DIMM configuration so that the Near Memory/Far Memory ratio meets firmware
requirements, then reboot the system.
. 169
Chapter 3 UEFI events