Advertisement
14
15
16
17
3 Parameter adjustment
3.1 Enter parameter mode and saving
Press
, enter parameter mode, then press
then press
or
out parameter mode, if already modify, firstly save parameter, then press
3.2 Enter technician parameter mode and save it
Press
and turn on the machine to enter technician parameter mode.The methods is same as
parameter mode.
3.3 Speed adjustment
Press
and
value is 50.
3.4 Factory setting
Press the
3.5 Enter monitoring system
Press
+
out.(if it is24、25、26、28, then press P to save this monitoring value as the corresponding parameter, if save
successfully, show OK, press P for short time to log out this mode. )
PS: Needle position setting, enter monitoring mode number 24, move the hand wheel to up needle position(the value will be
changed with hand wheel position), press
press
to log out this mode.
Down key(speed
down)
Key left
Right selection
Reset key
to modify this value, press
to adjust the speed. For up, to adjust fast, for down, to adjust slow.each adjustment
for a long time, back to the factory setting.
to enter this mode, press up and down key to adjust this parameter, press P, then can log
for long time to save it(after save it, down needle position will be adjust automatically),
Enter this mode, adjust this key, decrease speed
Turn to left to choose parameter
Turn to right to choose parameter
Press 3 seconds, then back to factory setting
or
to move the lit, corresponding number flashing,
, save the parameter. If not modified, press
5 / 14
to log
to log out parameter mode.
Advertisement
