General; Declaration Of Compliance; Safety Information; General Labelling Of Instructions In This Operating Manual - Homa AL3PS Instruction Manual

1. General

1.1. Declaration of compliance

EC declaration of compliance according to the
EC Machinery Directive 2006/42/EC, Annex II Part 1A
Manufacturer name and address:
HOMA Pumpenfabrik GmbH
Industriestrasse 1
53819 Neunkirchen - Seelscheid
We hereby declare that the machine:
AL3PS - Alarm- and pump switchgear
Follows relevant regulations:
Electromagnetic compatibility 2004/108 /EC
Low-voltage Directive 2006/95/EC
Person responsible for compiling the technical file
Vassilios Petridis
Head of Development and Production
HOMA Pumpenfabrik GmbH
This EC Declaration of Conformity was issued:
Oberheister, 27/01/2020
Vassilios Petridis
Head of Development and Production
HOMA Pumpenfabrik GmbH
This is an original operating manual within the meaning of the Machinery Directive.

2. Safety information

2.1. General labelling of instructions in this operating
manual
Safety information contained in this operating ma-
nual which must be followed in order to avoid danger
to persons is marked with a general danger symbol,
safety sign in accordance with DIN 4844-W 9.
Warnings regarding electrical voltage are marked
with a safety sign in accordance with DIN 4844-W.

2.2. General safety information

As well as the general safety information listed below, you
will find other safety information under the main points in
this operating manual. General regulations and standards
not mentioned here also remain valid.
This operating manual contains fundamental infor-
mation that is to be followed during setup, operation
and maintenance. Therefore, this operating manual
must be read before installation and operating by the
installer and operator and must always be kept at the
place where this equipment is used.
Persons not familiar with this operating manual may
not operate this equipment. Children and young per-
sons below the age of 16 may not use the equipment
and must be kept away from the equipment once
connected.
If work needs to be carried out with welding equip-
ment or electrical tools, ensure that there is no dan-
ger of explosion.
Immediately after work ends, all safety and protecti-
ve devices must be attached again or put back into
operation.
The operator is responsible for third parties in the
work area of the equipment.
We point out that, under German product liability law,
we are not liable for damage or injury caused by our
equipment if the information and regulations in this
operating manual are not complied with. The same
provisions apply to accessories.
ENGLISH | 13