Internal Networking; Internal Connections Between Icm And Mezzanine Network Adapter - H3C UniServer BX720EF User Manual

Internal networking

Internal connections between ICM and mezzanine
network adapter
Table 5 describes the internal connections between ICMs and mezzanine network adapters on blade
servers. Make sure the ICMs and mezzanine network adapters are installed in the correct slots so
that the internal connection requirements can be met.
Table 5 Connection between ICMs and mezzanine network adapters
Model of blade server
H3C UniServer B5700 G5
H3C UniServer B5700 G3
H3C UniServer B7800 G3
H3C UniServer B5800 G3
Figure 7 shows the connection method one for ICMs and mezzanine network adapters, where:
•
The embedded network adapter is connected to the active and standby OM modules.
•
Mezzanine network adapter 1 is connected to ICMs in slot 1 and slot 4.
•
Mezzanine network adapter 2 is connected to ICMs in slot 2 and slot 5.
•
Mezzanine network adapter 3 is connected to ICMs in slot 3 and slot 6.
Maximum number of
supported mezzanine
network adapters
3
3
6
3
1
Internal connections
Figure 7
Note
Figure 7
The connection diagram is a
logical diagram used to identify
Figure 8
the mapping relations between
mezzanine network adapter slots
and ICM slots. For more
information about the slot
Figure 7
locations of the mezzanine
network adapters and ICMs, see
the port numbers on the server.