6.4
Connect Power and Data Cables
This section is a guide to power in the Power bar and the data connection to the Hub boards
Warning!
Only trained personnel, such as electricians or NEC personnel, may
connect the internal power supply to mains power supply.
Table 10: Cable Connection Requirements
No. of People 1
Prerequisites
Cabinets securely installed
Mains power not connected
Tools
Screwdriver
Equipment
External power cable (not included in delivery)
Data cables from LED Wall to NovaStar Controller (Cat cable, FTP Cat5e)
D
L
A
N
PE
Figure 56: Connections in Power Bar
A
External power input
B
Terminal in Power bar
6.4.1
Connect Data Cables
Step 1)
Prepare the data connection according to the cabling plans, see 15.1 Cable Plans.
Each column of cabinets needs one data input cable from the video controller.
Step 2)
Run the data cable (see Figure 56, D) from the video controller through the Power bar
to the first Hub board of a column.
Push the cable through the hole in the Power bar.
Step 3)
Connect the data input to the left Ethernet ports on the Hub board.
Step 4)
From the first Hub board, connect the short
CAT cable to the next Hub board in the
cabinet above.
Push the cable through the hole in the
cabinet.
Step 5)
Repeat this procedure for the rest of the
cabinets and cabinet rows.
B
C
L
N
C
Power supply socket in Power bar
D
Data cable
PE
Figure 57: Connecting Two Cabinets
49