Install Further Cabinet Rows; Align Cabinets; Figure 54: Locking Two Modules; Figure 55: Adjustment Plates - NEC FE Series User Manual

6.3.4

Install Further Cabinet Rows

Step 1) Install the Cabinet hanger pins (see 6.3.1).
Step 2) Use the grip handles on the cabinet (Figure 48 in chapter 6.3.2, A) to bring it into
position at left corner on the first cabinet row.
Step 3) Align together the Cabinet hanger pins with the Mounting bar sockets (Figure 48, B)
and the Corner alignment pins on the cabinet below (Figure 48, C).
Lower the cabinet onto the Power supply socket (Figure 48, D), gently pressing it until
it sits firmly.
Notice
Place the cabinet carefully and straight on top of the Power supply socket.
Step 4) Install further cabinets until a row is complete.
Step 5) Connect each cabinet to its adjacent cabinets
with the Screw connections.
a) Place a delivered Allen screw (E) in the
screw connection anchor.
b) Only finger-tighten the screw to the
Counter plate (F) in the other cabinet.
Notice
Do not tighten the Screw connection too much.
Otherwise the cabinets cannot be aligned later on.
Step 6) For the top row, use type B cabinets only.
Proceed as described above.
6.3.5

Align Cabinets

After all rows of cabinets are installed, the cabinets have to be aligned with the Adjustment
plates.
Step 1) For each cabinet junction, attach one
Adjustment plate (A) with four screws, one on
each cabinet.
Step 2) Attach Adjustment plates also on the sides of
the LED Wall (B) and at the bottom over the
Power bar (C).
Step 3) After each cabinet junction has a Adjustment
plate, tighten all Screw connections hand tight.
By tightening the Screw connections properly,
the cabinets keep their aligned position.
Step 4) Remove all Adjustment plates.
E F

Figure 54: Locking Two Modules

B

Figure 55: Adjustment plates

A
C
48