Table of Contents
Advertisement
Hot Key Power On
Simply pressing on the preselected keyboard key the system will
power on.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install
an add-in FDC or the system has no floppy drive, select Disabled in
this field.
UART Mode Select
Select an operating mode for the second serial port:
Normal
Standard
IrDA 1.0
IrDA SIR
IrDA MIR
IrDA FIR
FIR
MIR 0.57M
MIR 1.15M
Sharp IR
HPSIR
ASK IR
UART2 Duplex Mode
In an infrated port mode, this field appears. Full-duplex mode
permits simultaneous two-direction transmission. Half-duplex
mode permits transmission in one direction only at a time. Select
the value required by the IR device connected to the IR port.
RS-232C serial port
RS-232C serial port
Infrared port compliant with IrDA 1.0
specification
IrDA-compliant serial infrared port
1 MB/sec infrared port
Fast infrared standard
Fast infrared standard
0.57-MB/sec infrared port
1.15-MB/sec infrared port
4-MB/sec data transmission
IrDA-compliant serial infrared prot
Amplitude shift keyed infrared port
Advertisement
Table of Contents
