Floppy Drive Connector (Cn19) - Aaeon PCM-6896 Manual

Floppy drive connector (CN19)

You can attach up to two floppy drives to the mainboard controller.
You can use any combination of 5¼" (360 KB and 1.2 MB) and/or
3½" (720 KB, 1.44 MB, and 2.88 MB) drives.
A 34-pin daisy chain drive connector cable for (CN19) is required
for a dual-drive system. On one end of the cable is a 34-pin flat
cable connector. On the other end are two sets of floppy disk drive
connectors. Each set consists of a 34-pin flat-cable connector
(usually used for 3½" drives) and a printed-circuit board connector
(usually used for 5¼" drives). Wire number 1 on the cable is
normally red or blue, and the other wires are usually gray.
Connecting the floppy drive
1. Plug the 34-pin flat-cable connector into CN19. Make sure that
the red or blue wire corresponds to pin 1 on the connector.
2. Attach the appropriate connector on the other end of the cable
to the floppy drive(s). You can use only one connector in the set.
The set on the end (after the twist in the cable) connects to the A:
drive. The set in the middle connects to the B: drive.
3. If you are connecting a 5¼" floppy drive, line up the slot in the
printed circuit board with the blocked-off part of the cable connec-
tor.
If you are connecting a 3½" floppy drive, you may have trouble
determining which pin is pin number 1. Look for a number printed
on the circuit board indicating pin number 1. Also, the connector
on the floppy drive connector may have a slot. When the slot is up,
pin number 1 should be on the right. Check the documentation that
came with the drive for more information. If you desire, connect the
B: drive to the connectors in the middle of the cable as described
above.
Please refer to the pin definitions on the next page.