Table of Contents
Advertisement
UM-PM-032
DA9068 GUI and Evaluation Board
6.8
Control Tabs
The tabs GPIO, Customer OTP, LDOs, Bucks, Power Sequencer, ADC, and RTC, all have the same
format.
Each register cluster comprises a control with a mixture of Boolean toggle buttons, multi-value ring
controls, or slide controls; a hex indicator showing the total equivalent value, a readback indicator
showing the current contents of the register. The readback indicator is labelled with the register
number in both decimal and hex.
Readback indicators can be switched individually by clicking on the x to decimal, octal, hex or binary,
or they may all be changed at once between hex and binary by the View, Binary Indicators menu
item.
Changing a register control immediately sends the value to the selected register, and reads the value
back again, comparing the result with the hex indicator. Note that all bits of the register are sent at
once. Therefore, this does not allow changing multiple bits simultaneously.
If the readback indicator is red, it indicates that the current value does not match. This might be
because the value has not been downloaded yet, or because the supply has been interrupted.
NOTE
Changes made to registers on these screens are not saved into the project file, they are purely temporary
changes.
User Manual
CFR0012
The Event Register is labelled with a register number in decimal and
its hexadecimal equivalent.
Hex equivalent of mask register bits.
Name of mask register bits, and also event names.
Event bit set. Press to clear and reset.
Readback of mask register, visible as hex or binary by using Binary
Indicators in the Settings menu.
Hex Indicator
Boolean control Bit 7
Boolean control Bit 6
Ring value control Bits 0-5
Readback Indicator
Revision 1.1
27 of 33
25-Feb-2022
© 2022 Renesas Electronics
Advertisement
Table of Contents
