Declaration Of Conformity - Advantech MIC-770 V3 Startup Manual

Specifications (Cont.)
This product is intended to be supplied by a UL-certified
power supply or UL-certified DC source rated 19 Vdc, 7.89A
minimum, TMA 50 °C minimum (safety certificate operation
temperature 40 °C). If you need further assistance, please
contact Advantech for further information.
Miscellaneous
• Power Switch
(Orange: System standby / Green: System Power boot)
• COM1 TX & RX LED; COM2 TX & RX LED; Storage
Status LED ((Blinking: read/write; Dark: no behavior)
Environment
• Operation Temperature:
TDP 35W CPU: -20 ~ 60 °C
TDP 65W CPU: -20 ~ 50 °C
Note: Safety Certification Test Temperature: safe max
60 °C with SSD (TDP 35W CPU) (Safety certificate opera-
tion temperature 60 °C)
• Storage Temperature: -40 ~ 85 °C (-40 ~ 185 °F)
• Relative Humidity: 95% @ 40 °C (non-condensing)
Physical Characteristics
• Dimensions (W x H x D): 77 x 192 x 230 mm
• Weight: 2.8 kg (6.17 lb)
The board has a number of jumpers that allow you to con-
figure your system to suit your application. The table below
lists the function of each of the jumpers and connectors.
Jumpers and Connectors
Connectors
Label Function
VGA1 VGA Connector
HDMI1 HDMI connector
COM 1/2 RS-232/422/485
COM 3/4, COM
RS-232
5/6
USB 1-4 USB 3.2 (R680E, iAMT) or USB 2.0 (H610E)
USB 5/6 USB 3.2
USB 7/8 USB 3.2
Intel® i219LM (R680E) or Intel® i219V
LAN 1
(H610E)
LAN 2 Intel® i210IT (iBMC)
Audio Audio Jack (Line-out, Mic-in)
LED COM 1/2 TX; RX; Storage device status
DC 9-36V Power connector
1
2
3
AT Module
PSON1: System AT/ATX Module Selection
Function Jumper Setting
1-2 AT module
2-3 ATX module (Default)
2 MIC-770 V3 Startup Manual
1
2
3
ATX Module
Battery
The computer is supplied with a battery-powered realtime
clock circuit. There is a danger of explosion if the battery is
incorrectly replaced. Replace only with the same or equiva-
lent type recommended by the manufacturer. Discard used
batteries according to the manufacturer's instructions.

Declaration of Conformity

This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired opera-
tion.
System I/O Interface
TX for COM1
RX for COM1
TX for COM2
USB3.2/2.0
RX for COM2
LAN2/ LAN1
Storage (SATA)
Power
USB3.2
Line out
MIC in iDoor
interface
Simple Maintenance Process
Memory Installation
MIC-770 V3 supports DDR5 SODIMM ECC/non-ECC type
memory module. If you need a detailed supported memory
list, please contact your distributor or sales representative to
order compatible memory modules.
COM1/2
VGA
Chassis GND
9 - 36 VDC
HDMI
Flex I/O
interface