Drilling - JEI AIRBEAST 35 ATEX Operator's Manual

AIRBEAST 35 ATEX
JEI GroupLtd
To do this, attach the end links of the chain to the snap hooks and grasp the hooks to
the lugs located on both sides of the machine (Figure 7). The chain must not be
loose. Wrap the chain around the workpiece if possible.
When working in the position from Figure 7a and 7c, fill the cooling system bottle with
a cutting fluid and attach the bottle hose to the coupling (Figure 1). Do not use pure
water as the cutting fluid, however, using emulsions formed from mixing water and
drilling oil is also satisfactory. Then, press the lever of the bottle several times, after
which rotate the feed lever to initially apply pressure on the pilot pin. The fluid will fill
the system and will begin flowing from the inside of the cutter.
Use a cooling paste when working in inverted positions
(Figure 7b).

3.3. Drilling

Start the motor by positioning the MOTOR lever vertically (1, Figure 8). Rotate the
feed lever counterclockwise (2) to bring the cutter close to the workpiece and gently
begin drilling. Maintain constant pressure on the lever. Accomplish the hole in one pass.
2
1
Figure 8. Method of starting the motor
AIRBEAST 35 ATEX Operator's Manual
12