Table of Contents
Advertisement
Safety information
Introduction
3
Mechanical Installation
Before installing or removing an option module from any drive, ensure the AC supply has been disconnected for at least 10 minutes and
refer to section 1 Safety information on page 4. If using a DC bus supply ensure this is fully discharged before working on any drive or
option module.
WARNING
3.1
General installation
For information on the installation of the SI-Encoder V2 option module please refer to the installation sheet provided with the option module.
NOTE
Option modules can only be installed on drives that have the option module slot functionality.
8
Mechanical Installation
Electrical Installation
Getting Started
Parameters
SI-Encoder V2 User Guide
Diagnostics
Advertisement
Table of Contents
Need help?
Do you have a question about the SI-Encoder V2 and is the answer not in the manual?
Questions and answers