Figure 9: Rf Connector Kit; Table 5: Mating Female Connector Housings 1 & 2; Table 6: Mating Female Crimps For Connectors 1 & 2; Table 7: Mating Female Connector 3 - Vix Assure Adept Validator Installation Manual

Both pole-mounted and surface-mounted Adept Validators use the same rear connectors with the same pinouts.
In most installations only one connector (26WAY) is required to be terminated onto the cable. The second
connector (20WAY) and the third connector (GPS) will be required only if external GPIO/USB/RS485/GPS etc. are
required in the installation.
The following defines the mating connectors/crimps and tooling requirements used on the cable harness that
connects to the Adept Validator.
•
Refer to the below two tables for the recommended connectors and crimps. The crimps should be selected
based on the connecting cable size and the current rating requirement.
•
Approved alternative connectors, that are compatible with the defined interfaces, can be used.
•
Defined tools should be used to ensure good termination coupling in both the cable manufacture and
installation.
CONN ID SIZE
1 26WAY
2 20WAY
SIZE MOLEX PART NUMBER
22-26 AWG 5016471000
22-24 AWG 5030952201
26-28 AWG 5016481000
26-28 AWG 5030952200
CONN ID STYLE
SMB
3 Right angle
50 Ohm
Connector # 3 comes in a kit of 6 components as shown below.
DPU-00084
Revision 2.3
Table 5: Mating Female Connector Housings 1 & 2
MOLEX PART NUMBER
5016462600
5016462000
Table 6: Mating Female Crimps for Connectors 1 & 2
RATING
2A
2A
1.5A
1.5A

Table 7: Mating Female Connector 3

AMPHENOL
PART NUMBER
3FA1ENZRJ-C01ER
Heat Shrink
Connector
Ferrule

Figure 9: RF Connector Kit

Page 19 of 39
PITCH MATERIAL
2mm Nylon
2mm Nylon
MATERIAL
Copper Alloy
Copper Alloy
Copper Alloy
Copper Alloy
CONTACT SHIELD
TERMINATION TERMINATION
Solder Crimp
Housing
Gasket
End Cap
POLARISED
Yes
Yes
PLATING WIRE
Tin 0.95-1.50mm
Gold 0.85-1.50mm
Tin 0.85-1.40mm
Gold 0.85-1.50mm
BODY
Zinc Die Cast
IP67