Front Bezel Assembly; Front Bezel - Compaq Deskpro 2000 Maintenance & Service Manual

6.16 Front Bezel Assembly

The front bezel must be removed before removing or installing the J hood, the power supply, or any
of the mass storage devices.

6.16.1 Front Bezel

The front bezel is attached to the computer chassis with release latches that are integrated into the
bezel. To remove the front bezel, complete the following steps:
1. Remove the access panel (Section 6.6.1).
2. From the inside of the chassis, push in the release latches 1 and push the side of the bezel out
and away from the chassis 2.
3. Rotate the front bezel out from the chassis, then slide it to the left.
4. Separate the bezel from the chassis.
Figure 6-25. Removing the Front Bezel
To replace the bezel, reverse the above procedure. Ensure that the hinge points at the side of the bezel
and the release latches are properly positioned before latching the bezel into place.
Compaq Deskpro 2000 Series of Personal Computers 6-25