System Board Components; Memory Modules - Compaq Deskpro 2000 Maintenance & Service Manual

5.9 System Board Components

5.9.1

Memory Modules

Memory may be expanded by adding one or more DIMMs at a time onto the system board.
CAUTION: Static electricity can damage the electronic components of the computer or optional boards.
Before beginning these procedures, ensure that you are discharged of static electricity by briefly touching
a grounded metal object.
CAUTION: When handling a memory module, be careful not to touch any of the contacts. Doing so can
damage the module.
To remove a memory module, complete the following steps:
1. Remove the system unit cover (Section 5.6).
2. Remove any outboard expansion boards that block the DIMM sockets (Section 5.8.2).
3. Press outward on both latches of the DIMM socket at the same time. This releases the module and
partially pushes it out of the socket.
4. Lift the module from the socket.
Figure 5-10. Removing a Memory Module
For the location of the DIMM sockets on the system board, see Chapter 7.
To replace a DIMM, reverse the above steps. Press down firmly on top of the DIMM to seat it. Make
sure that the latches are fully pushed in and locked.
When the computer starts up, it will recognize the system memory upgrades and
automatically reconfigure the computer.
5-12 Removal and Replacement Procedures - Desktop