Table of Contents
Advertisement
Maintenance
5.3.4 Internal Fan 2
If the warrning "Fan Fail- Internal F00" show on the DSS / APP, please follow
the procedure below to remove Internal Fan 2.
(1) Disconnect the power connector on the COMM. board. (Figure 5-12)
(2) Loose 2 self-retaining screws and remove the fan cabinet. (Figure 5-13)
(3) Lift the entire fan assembly. (Figure 5-14)
(4) Clean assembly or replace with a new fan.
(5) Reassemble by using 0.8 N•m tightening torque.
Fan connector
* Screw torque required for assembling: 0.8 N•m
Figure 5-12: Internal fan 2 location & remove the shield cover
69
Advertisement
Chapters
Table of Contents
