Table of Contents
Advertisement
5.3.3 Internal Fan 1
If the warrning "Fan Fail- Internal F01" show on the DSS / APP, please follow
the procedure below to remove Internal Fan 1.
(1) Remove the B cover.(Figure 5-9)
(2) Disconnect the power connector on the LED board.(Figure 5-9)
(3) Loose two self-retaining screws and remove the fan cabinet. (Figure 5-10)
(4) Lift the entire fan assembly. (Figure 5-11)
(5) Clean assembly or replace with a new fan.
(6) Reassemble by using 0.8 N•m tightening torque.
Fan connector
Figure 5-9: Internal fan 1 location & remove the shield cover
67
Maintenance
B
* Screw torque: 0.8 N•m
Advertisement
Chapters
Table of Contents
