• i80 Code - family : Auto Door Opener
• i80
code: Auto door opener malfunction
•
The error is set if the auto door opener sense signal indicates that it has
left the normal position unintentionally while running a cycle, or
•
If the auto door opener times out without reaching starting position three
times while retracting.
•
Timeouts are defined in MCF
•
Abort program and display error
• i81
code: Auto door opener warning
•
The warning is set if the auto door opener sense signal indicates that it has
left the normal position unintentionally, or
•
If the auto door opener times out while opening the door and does not
leave the starting position, or
•
If the auto door opener reverses direction while opening the door and
reach the inside position before expected (door blocked), or
•
If the auto door opener times out while retracting.
•
Timeouts are defined in MCF
•
The warning is not displayed, the cycle continues
• i82
code: Water Reuse valve warning
•
This warning is set if the Water Reuse valve is detected not opened during
the water tank conditioning, or
•
If the Water Reuse valve is detected not closed in the beginning of the cold
rinse phase in every Elabel or intensive Care cycle.
•
The warning is not displayed, the cycle continues.
Technical Support – A.R.
Alarm Codes
• i90 Code - family : Configuration Problem
• i91
code: checksum MCF
•
No washing program start is possible, can be resolved by turning the
appliance off and back on again.
•
The display board does not satisfy the identification requests of the main
board.
• i92
code: checksum CCF
•
The alarm is signalled if the configuration control of the washing cycles
provided erroneous results.
• i93
code: checksum UIDATA
•
The alarm is signalled if the configuration control of the UI configuration
data provided erroneous results.
• i94
code: UIDATA version mismatch
•
The alarm is signalled if the UIDATA provided in configuration file
mismatches the attached UI board.
• i95
code: UIDATA checksum mismatch
•
The alarm is signalled if the UIDATA checksum type provided in
configuration file mismatches with the attached UI board.
599 79 76 - 54 Rev 2
4
Chapter