Table of Contents
Advertisement
Installing Your Voice Terminal
Routing
channel
Figure 4. Line, Adjunct, Handset, & Expansion Module Cord Routing on
the 8434DX Voice Terminals
6. Turn the voice terminal right side up, with the front facing you.
7. Snap the free end of the handset cord into the handset and place the
handset in the cradle.
8. Snap the free end of the line cord into the modular wall jack.
Refer to the section, ''Attaching Adjunct Equipment'' later in this manual,
for information about connecting any 8400-Series voice terminal to the
wall jack when an adjunct is used.
18
EX MOD
LISTED
LINE
TELEPHONE
91B0
EQUIPMENT
R
MADE
A T & T
!
IN
U.S.A.
Adjunct
Line
Expansion
jack
jack
module
jack
Notes:
If you are installing an 8411 or 8434DX, connect the voice terminal
line cord to the PHONE jack on the MSP-1 power supply and then
connect a cord from the LINE jack on the MSP-1 to the wall jack.
You can use a 2-wire/4-wire adapter to upgrade an analog-type
RJ11C jack to an 8-wire RJ45X-type jack. For more information,
see ''The 2-Wire/4-Wire Line Adapter'' earlier in this manual.
Handset
R
USE ONLY WITH
COMMUNICATION
CIRCUIT POWER
SOURCE
jack
Advertisement
Table of Contents
