Table of Contents
Advertisement
Installing Your Voice Terminal
3. For all sets, thread the line cord (and adjunct cord, if applicable) through
the routing channel leading to the top of the desktop stand, as shown in
Figure 2, Figure 3, or Figure 4, according to the type of terminal you are
using. Make sure that each cord is placed securely under the square tabs
in the routing channel.
4. If you are using an 8434DX with an attached 801A Expansion Module,
plug the D6AP-87 cord, shipped with the expansion module, into the
Expansion Module jack on the 8434DX (labeled ''EX MOD'') and then plug
the free end of the cord into the jack on the expansion module. The cord
should be threaded through the routing channels on the voice terminal.
See Figure 4. For more detailed instructions on installing the expansion
module to the 8434DX, use the instructions titled ''801A Expansion
Module Instruction Manual,'' shipped with the expansion module.
Important: An 801A Expansion Module can be used ONLY with an
8434DX voice terminal connected to a DEFINITY G3V3.3 or later switch.
5. For all voice terminals, snap one end of the coiled cord into the Handset
jack (this jack is labeled
channel leading to the side edge of the voice terminal; the handset cord
will then lead off the side of the voice terminal.
and plug the cords into the jacks BEFORE you insert the desktop
stand onto the back of the voice terminal.
NOTE:
If you are routing cords on the 8411, lift the kickstand and place the
cords under the kickstand.
WARNING:
Do not insert the handset cord into the Adjunct jack. It may cause
equipment damage.
). On an 8403, thread the cord into the
15
Advertisement
Table of Contents
