Rooms & Presets; Assign Dimmers To Rooms; Create A Preset (Web Only) - ETC sensor+ CEM+ Manual

Rooms & Presets

Assign Dimmers to Rooms

All dimmers in a group default to being in (and thus available only to) Room1. You can assign a dimmer
or range of dimmers to any of the rooms (1-4), but to only one room at a time. Shown below, dimmers
101-112 are assigned to Room1 and dimmers 113-114 are assigned to Room2.

Create a Preset (Web Only)

In the web interface, you must create a preset before you can record levels into it. The face panel
combines creating a preset with recording it.
Click on Create New and the web interface will add a new preset to the list below. It will add an
incremental preset (Preset1, Preset2, Preset3 and so on) or if an older preset was recorded, it will
recycle the old preset first before making a new one. Once it appears in the list, you can record and
modify it as needed.
46
Use this section to assign an individual dimmer to a room.
Dimmers may only be assigned to a single room at a time.
Use this section
to assign a
range of
dimmers to a
room.
Sensor+ CEM+ User/Config Manual