Unpacking And Cleanup - Jet JJ-8CS Operating Instructions And Parts Manual

Unpacking and Cleanup

Contents of Shipping Cartons
Note: Unit shipped in two cartons.
Stand Carton
1 Stand with Motor
1 Stand Door
1 Dust Chute with Mounting Hardware
1 Pedestal Switch with Mounting Hardware
(JJ-8HH only)
Main Unit Carton
1 Bed Assembly
1 Fence Assembly
1 Cutterhead Guard
1 Belt Guard
2 V-Belts
2 Handwheels with handle
1 Fence Handle
3 Mounting Bolts
3 3/8" Lock Washers
1 Operating Instructions and Parts Manual
1 Warranty Card
Tools Included with JJ-8CS
1 12/14mm Open End Wrench
1 8/10mm Open End Wrench
3 Hex Wrenches (3, 4 and 5 mm)
1 Knife Gauge Assembly
Tools included with JJ-8HH:
1 12/14mm Open End Wrench
1 8/10mm Open End Wrench
4 Hex Wrenches (3, 4, 5, 6 mm)
2 Star Point Screwdrivers
5 Knife Inserts
10 Knife Insert Screws
Tools Required for Assembly:
#1 Cross Point Screwdriver
6-8" Adjustable Wrench or 17 & 19mm Wrench
Unpacking and Cleanup
1. Carefully finish removing all contents from
both shipping cartons. Compare contents of
the shipping cartons with the list of contents
above. Place parts on a protected surface.
2. Set packing material and shipping cartons to
the side. Do not discard until machine has
been set up and is running properly.
3. Clean all rust protected surfaces (bed,
fence, etc.) with kerosene or diesel oil. Do
not use gasoline, paint thinner, mineral
spirits, etc. These may damage painted
surfaces.
7