Database Versions Page; Instrument Panel Self-Test Page; To Enter Fuel Capacity, Fuel On Board Or Fuel Flow Figures - Garmin GNS 430 Pilot's Manual & Reference

SECTION 1
INTRODUCTION
The Database Versions Page (Figure 1-4) appears
next, which shows the current database information
on the NavData and Terrain Data cards.
information highlighted in yellow indicates the database
is not within its effective dates. The NavData database is
updated every 28 days and must be current for approved
instrument approach operations. Information on database
subscriptions is available inside the GNS 430 package.
Figure 1-4 Database Versions Page
To acknowledge the database information:
Press the ENT Key.

Instrument Panel Self-test Page

Once the database has been acknowledged, the
Instrument Panel Self-Test Page appears (Figure 1-5).
Figure 1-5 Instrument Panel Self-Test Page
1-6
To ensure that the GNS 430 and any connected
instruments are working properly, check for the following
Database indications on the CDI/HSI, RMI, external annunciators,
and other connected instruments:
• Course deviation - Half left/no flag
• TO/FROM flag - TO
• Bearing to destination - 135°
• Distance to destination - 10.0 nm
• All external annunciators (if installed) - On
• Glideslope - Half up/no flag
• Time to destination - 4 minutes
• Desired track - 149.5°
• Ground speed - 150 knots
The Instrument Panel Self-test Page (Figure 1-5)
indicates the currently selected OBS course, fuel capacity
(CAP), fuel on board (FOB), and fuel flow (FF). The fuel
capacity, fuel on board, and fuel flow may be manually
entered if the installation does not include connection to
sensors which automatically provide these figures.
To enter fuel capacity, fuel on board or fuel
flow figures (if not provided by sensors):
1)
GNS 430(A) Pilot's Guide and Reference
Turn the large right knob to select the 'CAP',
'FOB', or 'FF' field.
190-00140-00 Rev. P