Table of Contents
Advertisement
STEP 3
1. Use 5# hexagon wrench to secure M8*42
hexagon round head screw (73) and internal
sawtooth lock gasket (90) on the upright
column to the main frame base.
2. Use 5# hexagon wrench to secure M8*16
hexagon round head screw (74) and inner
sawtooth lock washer (90) on the upright
column to the main frame base.
3. Repeat the installation step on the other
side.
NOTE:
Support the upright with your hands to
prevent it falling and causing injury.
74
90
73
STEP 4
1. Carefully raise the display into the position as
pictured.
2. Do not damage the display wire when doing so.
3. Using a 5# inner hexagon wrench, secure
M8*16 hexagon round head screw (74) and inner
sawtooth lock washer (90) on the upright
column and display.
4. Repeat the same steps on the other side.
NOTE:
When un-folding, do not press the cable
line inside the column and check whether
the wire is well connected. Lock the screw
by hand first to avoid the column and the
display from falling down.
74
90
ASSEMBLY INSTRUCTIONS |
9
Advertisement
Table of Contents
