Table of Contents
Advertisement
Configuring SNTP
To obtain time information from the time server on the network, configure Simple Network Time Protocol (SNTP).
When SNTP is configured, the time server is checked at specified intervals to adjust the time and maintain the correct
time on the machine.
The machine supports both an NTP server (NTPv3) and SNTP server (SNTPv3 and v4).
Configure these settings using Remote UI from a computer. You cannot use the operation panel to configure the
settings.
Administrator privileges are required. The machine must be restarted to apply the settings.
Required Preparations
●
The time is adjusted based on the UTC (Coordinated Universal Time), so specify the time zone setting.
Setting the Date and Time(P. 345)
●
Prepare the IP address of the NTP or SNTP server and keep it close by.
1
Log in to Remote UI in System Manager Mode.
2
On the Portal page of Remote UI, click [Settings/Registration].
Remote UI(P. 349)
3
Click [Network Settings]
➠
The [Edit SNTP Settings] screen is displayed.
4
Select the [Use SNTP] checkbox.
5
In [NTP Server Name], enter the IP address of the NTP/SNTP server.
When using a DNS server, you can enter the host name or FQDN instead of the IP address.
Input example:
ntp.example.com
6
In [Polling Interval], enter the interval at which to check the server and adjust the
time.
7
Click [OK].
8
Restart the machine.
➠
The settings are applied.
Setting Up
[SNTP Settings]
Restarting the Machine(P. 105)
85
Starting Remote UI(P. 347)
[Edit].
94WS-020
Portal Page of
Advertisement
Table of Contents
