Complete The Parts Replacement - Lenovo ThinkSystem ST250 V2 Maintenance Manual

Figure 122. Installing a tape drive
Step 3. Connect the power and signal cables to the rear of the tape drive. See "Optical/tape drives" on
page 66.
After this task is completed
Complete the parts replacement. See "Complete the parts replacement" on page 217.

Complete the parts replacement

Use this information to complete the parts replacement.
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
2. Properly route and secure the cables in the server. Refer to the cable connecting and routing information
for each component.
3. If you have removed the server cover, reinstall it. See "Install the server cover" on page 201.
4. Reconnect external cables and power cords to the server.
Attention: To avoid component damage, connect the power cords last.
5. Update the server configuration.
• Download and install the latest device drivers:
• Update the system firmware. See "Firmware updates" on page 9.
• Update the UEFI configuration.
• Reconfigure the disk arrays if you have installed or removed a hot-swap drive or a RAID adapter. See
the Lenovo XClarity Provisioning Manager User Guide, which is available for download at:
datacentersupport.lenovo.com
http://datacentersupport.lenovo.com
.
Chapter 4 Hardware replacement procedures
http://
217