Install The 3.5-Inch/2.5-Inch Drive Cage - Lenovo ThinkSystem ST250 V2 Maintenance Manual

If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.

Install the 3.5-inch/2.5-inch drive cage

Follow instructions in this section to install the 3.5-inch/2.5-inch drive cage.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read the "Installation guidelines" on page 85 to ensure that you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
DoEcxrm2zKNpaKOdZ3f8Qc
Procedure
Step 1. Install the backplane or backplate (see "Install the 3.5-inch/2.5-inch hot-swap drive backplane" on
page 95 or "Install the 3.5-inch simple-swap drive backplate" on page 98 ).
Step 2. Slide the drive cage in until the release latch clicks into place.
https://youtube.com/playlist?list=PLYV5R7hVcs-
.
.
Chapter 4 Hardware replacement procedures
91