Table of Contents
Advertisement
Make sure the requirements below are met
when installing the printer. The service
engineer should inspect the place the
printer will go before delivery.
1. Power supply
Line voltage: No more than +lO% outside
l
the rated voltage
Line frequency: W/60 ? 2 Hz
l
2. Operating conditions
Flat level, supporting surface
l
Ambient temperature of 10
l
. No condensatfon
. Good ventilation
to
.
.
In the sun
If the printer must go somewhere sunny,
the wlndows must have curtains keep to
.
Near magnets or equipment that produces
a magnetic !leld
.
Where there is vibration
.
Where it is dusty
.
Near flames or water
3.
There must be an enough space around the
printer to operate it. (See Figure 4-l) The
printer must go on a desk or other level
surface large enough to accommodate its
feet (and those of the paper feeder, if
used] and sturdy enough to carry its
weight.
1 2 9 2 m m
Figure 4-1
the
places:
Advertisement
Table of Contents
