Epson Stylus Pro 10000 Archival Ink Printer Manual page 21

Warning
If ink gets on your hands,
wash them thoroughly with
soap and water. If ink gets
in your eyes, flush them
immediately with water.
Note
If you can't insert the
cartridge smoothly,
you may have the
wrong cartridge.
Caution
Never turn off the printer,
change the position of
the paper set lever, or
open the lower cover or
ink compartment cover
while the Pause light
is flashing.
5. Hold the cartridge so the arrow mark on the left side of the cartridge is
pointing to the rear of the printer. Insert the cartridge into the slot.
Don't force it.
6. Push the clamp back up into the locked position.
7. Repeat steps 3 through 6 for the other ink cartridges. When you're
done, close the ink compartment cover.
The printer begins charging the advanced ink delivery system. The
light on the control panel flashes and the printer makes various sounds.
Charging takes about 4 minutes. Do not turn off the printer or interrupt
this important process or you'll use up more ink than necessary. When the
light stops flashing and
Pause
display, you're ready to load the roll paper.
1-3
Setting Up the Printer
appears on the control panel
Paper Out
| 1-3
Pause