Windows System Requirements - Epson Stylus Pro 10000 Archival Ink Printer Manual

6 | Introduction
Note
If you are not using Photo
Printing Accelerator in
your driver (see page 4-3
for details), or if you
are using a software or
hardware RIP, you
must have a Pentium III
700 MHz or higher
processor with 512MB
RAM to keep the printer
running at full engine
speed.
Caution
Using an improperly
shielded USB cable—
especially a cable more
than 6.6 ft. (2 meters)
long—may cause the
printer to malfunction.

Windows System Requirements

To use your printer in either a standalone or peer-to-peer network
environment, your system should include the requirements listed below:
IBM ® -compatible PC with a Pentium
•
recommended
For parallel connection: Windows 95, 98, Me, NT 4.0, or 2000
•
For USB connection: PC with USB port running Windows 98 (factory
installed), Me, or 2000
For IEEE 1394 connection: PC with FireWire port running
Windows Me or 2000
For 10/100 BaseT Ethernet connection: Ethernet equipped PC running
Windows 95, 98, Me, NT 4.0, or 2000
256MB of RAM
•
At least 50MB of free hard disk space to install the software, and at least
•
150MB of free hard disk space for processing files (2GB or more
available hard disk space recommended)
Quad-speed (4×) CD-ROM or DVD drive for installing the printer
•
software
For parallel connection: a high-speed bidirectional, IEEE-1284
•
compliant parallel cable, 6 to 10 ft. (1.8 to 3 m) long, with a D-SUB,
25-pin, male connector for your computer and a 36-pin, Centronics
compatible connector for the printer
For USB connection: a computer running Windows 98, Me, or 2000
with a Windows compliant USB port and a shielded USB "AB" cable
from Series A (computer) to Series B (printer), up to 6.6 ft. (2 meters)
long
For IEEE 1394 (FireWire) connection: a compliant IEEE 1394 port
and a shielded IEEE 1394 cable
For network connection: the optional EpsonNet Print Server (described
on page 2) and compatible cable
® II 400 MHz or higher processor
6
®