Responding To Control Panel Lights And Messages - Epson Stylus Pro 10000 Archival Ink Printer Manual

Error messages
Message Light
COVER OPEN Pause light on
INK Pause light on
COMPART.OPEN
CLOSE INK CART. Pause light on
COVER
INK LOW Ink Out light(s)
flashing
INK OUT Ink Out light(s)
on
LOAD PAPER Paper Out
light on
LOAD ROLL Paper Out
PAPER light on
LOAD SHEET
PAPER
MAINTENANCE —
REQ. <error
number>
MAINTENANCE —
REQ 0100
NO INK Ink Out light(s)
CARTRIDGE on
OPTION I/F —
ERROR
Monitoring and Configuring the Printer
Responding to Control Panel Lights and
Messages
When your ink or paper runs out or a problem occurs, a message appears on
the display. The lights on the control panel come on or flash. The following
table lists the messages alphabetically and includes an explanation and
instructions for correcting the problem.
Explanation
Lower cover is open.
You are replacing the
ink cartridge(s) and the
ink compartment cover
is open.
The ink compartment
cover is open.
Ink cartridge(s) are
nearly empty (printing
continues).
Ink cartridge(s) are
empty (printing stops).
Paper set lever is in the
released position (all
the way out) while
loading paper.
Paper source setting in
printer software is
different from control
panel.
A printer part will need
to be replaced soon.
The waste ink system
is almost full.
Ink cartridge(s) not
installed.
Wrong interface card
installed.
5-5
Response
Close the lower cover.
Close the ink compartment cover when you are
finished replacing the ink cartridge(s).
Close the ink compartment cover.
Replace ink cartridge(s) indicated by Ink Out
light(s). See page 6-7 for instructions.
Replace the ink cartridge(s) indicated by Ink
Out light(s). See page 6-7 for instructions.
After you finish loading paper, push the paper
set lever all the way in, to the secured position.
Make sure the right paper is loaded and the
paper source setting is the same on the control
panel and printer software.
Note the error number and contact EPSON as
described on page 4.
Call an authorized EPSON servicer to schedule
replacement of the waste ink system.
Install ink cartridges as indicated by the lights.
See page 6-7 for instructions.
Turn off the printer and remove the card. See
the documentation that came with the card.
| 5-5