Cleaning The Printer - Epson Stylus Pro 10000 Archival Ink Printer Manual

6-14 | Maintaining and Transporting the Printer
Caution
Be careful not to touch
the gears inside the
printer.
To avoid damaging the
components as well as
the case, never use
alcohol or thinners to
clean the printer.
Be careful not to get
water on the printer
mechanism or electronic
components.
Don't use a hard or
abrasive brush.
Don't spray the inside
of the printer with
lubricants; unsuitable
oils can damage the
mechanism. Contact your
dealer or a qualified
servicer if your printer
needs lubrication.
4. Push the side pin toward the back while pushing the front half of the
paper cutter cover down to close the casing. Then release the side pin.
CLOSE LOWER COVER
5. Close the lower cover. The cutter holder moves to the home (far right)
position and
READY

Cleaning the Printer

To keep your printer working at its best, you should clean it thoroughly
several times a year.
1. Make sure the printer is turned off and all the lights on the control panel
are off. Then unplug the power cord and disconnect the printer from
the computer.
2. Open the roll paper cover and remove the roll paper spindles. Remove
any sheet media from the printer. Then use a soft brush to carefully
clean away any dust or dirt.
3. Close the roll paper cover.
4. Open the lower cover and use a soft brush to carefully clean away any
dust or dirt inside the lower cover. Then close the cover.
5. Remove the paper hammock. Then clean away any dust or dirt around
the leg assembly using a soft brush.
6-14
appears on the display.
appears on the display.