Setting Up The Printer; Installing The Ink Cartridges - Epson Stylus Pro 10000 Archival Ink Printer Manual

Chapter 1:
Setting Up
the Printer
Note
Before you begin this
chapter, complete the
instructions in the
Unpacking and
Assembly Guide.
Note
The ink cartridges that
came with your printer
include a special chip
that causes the printer to
initialize as the correct
ink model. Make sure
you install these ink
cartridges when you
set up the printer.
Once you've assembled the printer, you're ready to finish setting it up. Even
if you have no experience, you can easily complete this process. You should
allow at least two hours so that you don't feel rushed.
This chapter covers the following information:

Installing the ink cartridges

•
Loading the roll paper
•
Running a nozzle check
•
Connecting the printer to your computer
•
Installing the printer software and configuring it for network use, if
•
necessary
Aligning the print head from the printer software
•
Installing the Ink Cartridges
It's important that the first ink cartridges you install be the ones that came
with the printer. The chips on these cartridges are programmed to cause the
printer to initialize as the correct ink model: Archival Ink or Photographic
Dye Ink. Ink cartridges that you later buy from EPSON do not have the
same program on their chips.
Before you begin, make sure that the printer is plugged into a grounded
outlet. Then locate the ink cartridges that came with the printer. Follow
these steps to install the cartridges:
1. Press the P
Power
1-1

Setting Up the Printer

button on the control panel to turn the printer on.
| 1-1