Stihl TSA 230 Instruction Manual page 38

English
2.10 Before starting work
Inspect the parting-off grinder for safe-to-operate
state – observe the respective chapters in the
instruction manual:
– Trigger switch and trigger switch lockout must
move easily – trigger switch and trigger switch
lockout must return to initial position when
released
– The abrasive wheel must be suitable for the
material to be cut. It must be in good condition
and fitted correctly (direction of rotation,
secure).
– Trigger switch is locked when the trigger
switch lockout is not depressed
– Locking lever easy to set to ‚ or ƒ
– Never attempt to modify the controls or safety
devices in any way
– Keep the handles clean, dry and free of oil as
well as dirt – important for safe guiding of the
parting-off grinder.
– Check contacts in the battery compartment of
the cut-off machine for foreign matter and dirt
– Fit the battery correctly – it must engage audi‐
bly
– Do not use defective or deformed batteries
– For wet applications, provide sufficient water
The cut-off machine should only be used if it is in
full working order – risk of accident!
2.11 Switching on the machine
On even ground, ensure a firm and secure foot‐
ing and hold the cut-off machine firmly – the
abrasive wheel must not touch any objects or the
ground and must not be in cutting action.
The cut-off machine is a one-person unit. Do not
allow other persons to be near the machine.
Switch on as described in the Instruction Manual
– see "Switching on the machine".
After releasing the trigger switch, the abrasive
wheel keeps on running for a while – danger of
injury due to coasting effect!
2.12 During operation
Use the cut-off machine only for hand-held cut‐
ting.
Ensure you always have a firm and secure foot‐
ing.
38
Always hold the cut-off machine firmly with both
hands: Right hand on the rear handle – even if
you are left-handed. To ensure reliable control,
wrap your thumbs tightly around the handlebar
and handle.
When a cut-off machine with an abrasive cutting
wheel rotating is moved in the direction of the
arrow, a force is produced which causes the
machine to tip sideways.
The object to be parted-off has to be firmly sup‐
ported. Always guide the cut-off machine
towards the workpiece – never in reverse.
Set the abrasive cutting wheel guard so that par‐
ticles of material are guided away from the user
and cut-off machine.
Note the direction of travel of the abraded parti‐
cles of material.
2 Safety Precautions
0458-707-9821-C