How To Use Your Radio - AnyTone ARES II Instruction Manual

HOW TO USE YOUR RADIO

OFF/ON Radio
1. Turn VOL clockwise to switch on the radio, the radio emit a beep. When the LED
displays frequency or channel, the radio is on.
2. Turn VOL anti-clockwise to switch off the radio, the radio is OFF when hear Ka
Ta from the switch.
Volume Control
When the radio is turned on, turn VOL clockwise will increase the volume, turn VOL
anti-clockwise will reduce the volume.
Note: Adjust the volume during communication to get suitable level.
Squelch Control
When the radio is standby, turn SQ outter shaft clockwise to adjust squelch level.
Mic Gain Control
When the radio is transmiting, turn MIG inner shaft to adjust Mic gain. Turn it clockwise
to increase gain, anti-clockwise to reduce gain.
RF Gain Control
When the radio is receiving, turn RFG outter shaft to adjust RF gain. Turn it clockwise
to increase gain, anti-clockwise to reduce gain.
RF POWER Concentric
Valid forr AM and FM mode only. Reducing the power for communication with a radio
without RF gain, default set to maximum for normal use.
Scan Function
CB Channels Scan (long press 7 seconds)
(1) In CB mode, press and hold [UP/DN] keys in the microphone for 7 seconds until hear a
beep sound, the CB scan function starts.
The dot between the two channel digits flashes to indicate that the scanning is active.
(2) Rotary channel switch or [UP/DN] keys in the microphone to change scan direction.
(3) short press [PTT] to exit scan.
WX Channels Scan (long press 3 seconds)
(1) In WX mode, press and hold [UP/DN] keys in the microphone for 3 seconds until hear a
beep sounds to start WX scan function.
The dot between the two channel digits flashes to indicate that the scanning is active.
(2) Rotary channel switch or [UP/DN] keys in the microphone to change scan direction.
(3) Short press [PTT] to exit scan.
Working Mode Control
Turn the mode switch to choose PA/FM/AM/USB/LSB mode.
Working Band Control
Turn the band switch to choose A/B/C/D/E/F band.
Channel Selection
Turn the channel knob to select desired channel.
Clockwise to increase, anti-clockwise to reduce channel.
8