Using Cut Sheet Media - Epson Stylus Pro 11880 User Manual

User's Guide
D
Hold the black movable flange as shown in
the figure and remove it from the spindle.
With some types of roll paper, the black
movable flange is removed by lightly
tapping the spindle.
When removing it when just the core of the
paper roll is left, hold the core and push on
the spindle.
Caution:
c
When removing the paper roll, do not
knock the left end of the spindle (the black
movable flange side) against the floor.
Doing so may damage the left end of the
spindle.
E
Remove the paper roll from the spindle.
After rewinding the roll paper carefully,
place it in the bag and box that it came in
when you purchased it.
Attach the black movable flange to the
spindle, and insert it in the printer.

Using Cut Sheet Media

The procedures differs depending on your paper
length and thickness.
Paper Paper
thickness length
Less than Longer than
0.5 mm Super A3/B
Super A3/B
or below
0.5 to 1.5 mm All
(thick paper)
Note:
❏ Flatten the paper before loading it in the printer.
If paper that is wavy or slack is loaded, the printer
may not recognize the paper size correctly or may
not print normally.
Also, we recommend that you replace the paper in
its original packaging and store it flat, only
taking it out of the bag just before you use it.
❏ If roll paper is loaded, rewind it first before
loading single sheet paper.
❏ When you use paper other than Epson special
media, see the instructions included with the
paper, or contact your supplier for more
information.
Refer to
"Loading cut
sheet media
longer than
Super A3/B
(483 mm)" on
page 36
"Loading cut
sheet media with
a length of Super
A3/B (483 mm) or
below" on page
38
"Printing on
thick paper (0.5
to 1.5 mm)" on
page 38
Paper Handling 35