Conveyor Assembly - Sega SpongeBob SQUAREPANTS Owner's Manual

12. Conveyor Assembly

Motor
Adjusting Belt Tension
This conveyor has an Adjustor on both sides of the assembly which can be used to set the tension of the
belt. Tension can be adjusted (2) ways using the tensioner.
1- Through tightening the Tension screw you will decrease tension on the roller to the belt.
2- Through tightening the Nut on the Bolt you will increase tension on the roller to the belt.
NOTE: The same amount of tension should be applied to both sides of the conveyor assembly to assure
uniform belt wear.
Changing Conveyor Belt
Decrease the belt tension as described above.
●
Tear the old belt off along the seam in the belt. (Where it's taped together.)
●
Wrap the new belt around the conveyor assembly. Remove the Backing to the double sided tape.
●
Adhere the end of the belt to the double sided tape squarely.
NOTE: Replace worn belts immediatly to keep optimum performance with your game unit.
Tension Nut
Tension Screw
15
Tensioner
www.seuservice.com