Ametek LAND MILLWATCH User Manual page 43

Single Stream
Unit
Parameter
FUEL 2 k2
FUEL 2 CO MAX
FT MIN
FT MAX
FT ZERO
AMB MIN
AMB MAX
AMB ZERO
UNITS
O2 NORM
O2 REF
WET ANALYSIS
WATER
CO2 COMP
SHOW NEGATIVE
ENTRY CODE
BLOW BACK
SET CLOCK
CLEAR FAULTS
RESTORE CONST.
OUTPUT CO2
The following information is found under "System Data".
CO Span Constants
O2 Span Constants
O2 Span Constants can only be changed with a calibration.
User Guide
Actual
Setting
N/A
N/A
N/A
CO Span Constants can be changed in the Setup.
RED CELL
Units Description
Calculation constant (k2) for Fuel
Type 2.
Stoichometric value of Fuel Type 2.
DegC Minimum value for the flue
temperature CLIP.
DegC Maximum value for the flue
temperature CLIP.
mA Minimum current for the flue
temperature CLIP.
DegC Minimum value for ambient
temperature CLIP.
DegC Maximum value for the ambient
temperature CLIP.
mA Minimum current for ambient
temperature CLIP.
Units used for gas concentrations.
O2 normalisation applied.
O2 reference value for normalisation.
Wet analysis applied to gas
concentrations.
Water vapour concentrations for wet
analysis.
CO2 factor for O2 compensation.
Allows display and output of negative
values.
Allows new code to be entered.
Manually purge the probe.
Allows system clock to be set.
Clears fault flags (Ongoing faults
remain flagged).
Restores the previous calibration
constant settings.
Allows CO2 to be output on current
loop O/P 4.
BLUE CELL
Millwatch / Silowatch
37