Ametek LAND MILLWATCH User Manual page 42

Millwatch / Silowatch
Appendix 1 Parameter Record Sheets
Use the tables below to record your parameter settings.
Unit
Parameter
ALARM 1
ALARM 2
O/P 1 MIN
O/P 1 MAX
O/P 1 SPAN
O/P 1 DAMPER
O/P 2 MIN
O/P 2 MAX
O/P 2 SPAN
O/P 2 DAMPER
O/P 4 MIN
O/P 4 MAX
1 RED COEFF 1
1 RED COEFF 2
1 BLUE COEFF 1
1 BLUE COEFF 2
PUMP INTERVAL
BLOW BACK
INTERVAL
FUEL
EFF. O/P
FUEL 1 k1
FUEL 1 k2
FUEL 1 CO MAX
FUEL 2 k1
36
Actual Units
Setting
ppm
Percent
mA
mA
ppm
6 secs
mA
mA
Percent
6 secs
mA
mA
minutes
minutes
Description
Sensor 1 alarm level.
O2 alarm level.
Minimum current for sensor 1 gas
current loop O/P.
Maximum cureent for sensor 1 gas
current loop O/P.
Sensor 1 gas full scale O/P.
Sensor 1 gas current loop O/P
response time.
Minimum current for O2 current loop
O/P.
Maximum cureent for O2 current loop
O/P.
O2 full scale O/P.
O2 current loop O/P response time.
Minimum current for NOx current loop
O/P.
Maximum current for Nox current
loop O/P.
Span calibration constant for sensor 1
on red channel.
Mid-Point calibration constant for
sensor 1 on red channel
Span calibration constant for sensor 1
on blue channel.
Mid-Point calibration constant for
sensor 1 on blue channel
Minutes between drain pump
operations.
Minutes between purge intervals.
Fuel type selection.
Selects output for O/P 4 as efficiency
loss.
Calculation constant (k1) for Fuel
Type 1.
Calculation constant (k2) for Fuel
Type 1.
Stoichometric value of Fuel Type 1.
Calculation constant (k1) for Fuel
Type 2.
Single Stream
User Guide