Software I-Prime Command (Ibm/E/Ml); Stop Printing Command (Ibm) - Oki MICROLINE ML521 Reference Manual

Parameters L and H
n n
Parameters L and H are used to designate the quantity of data, as follows:
n n
Parameter P
n
Parameter P sets the increment of movement. It can have any value from 0 to 255.
n

Software I-Prime Command (IBM/E/ML)

ML320 Turbo, ML321Turbo
ML390 Turbo, ML391Turbo
Function
Software I-Prime
This command clears the print buffer and resets the printer to the default settings, regardless of
the setting for the Reset Inhibit item in the printer menu.
If the Cut Sheet Feeder (CSF) is installed, this command will also eject any paper loaded into
the printer from the CSF.

Stop Printing Command (IBM)

ML390 Turbo, ML391Turbo
Function
Stop Printing (Deselect)
This command deselects the printer so that it will stop printing. To resume printing, press the
SEL switch, or–if "Auto Select" is set to "Yes" in the menu–reload paper.
L + (H
n
Table 101: Epson ESC ( U Command —
Increments of Movement for P
P
n
0 to 9
10 to 19
20 to 29
30 to 39
40 to 49
50 to 59
60 to 69
70 to 255
ML520, ML521
ML590, ML591
ASCII Dec
ESC } NUL 27 125 0
ML590, ML591
ASCII Dec
ESC j 27 106
Chapter 12: Miscellaneous Commands
x 256)
n
Values
n
Increment
Unchanged
1/360"
11/80"
1/120"
1/90"
1/72"
1/60"
Unchanged
Hex
1B 7D 00
Hex
1B 6A
131