Conventions Used In This Manual - Oki MICROLINE ML521 Reference Manual

Conventions Used in this Manual

The following conventions are used in the command chapters of this manual:
The emulation(s) to which each command applies is given in parentheses at the end of the
heading for the command. The emulations (IBM = IBM Proprinter, E = Epson FX, and ML =
OKIDATA MICROLINE Standard) are described in Chapter 1.
For example:
Proportional Spacing Commands (IBM/E/ML)
The printer models to which each command applies are given immediately below the
command heading, preceded by a check mark ( ).
ML320 E/I, ML321 E/I = Models ML320 & ML321, Epson/IBM-Compatible
ML320 Std., ML321 Std. = Models ML320 & ML321, MICROLINE Standard Emulation
ML320T, ML321T = Models ML320 Turbo & ML321 Turbo
ML390T, ML391T = Models ML320 Turbo & ML321 Turbo
ML520, ML521 = Models ML520 & ML521
ML590, ML591 = Models ML590 and ML591
For example:
Proportional Spacing Commands (IBM/E/ML)
ML320 E/I, ML321 E/I
ML320 Std., ML321 Std.
Text denoting lines of BASIC programming is set in the Courier font.
For example:
LPRINT CHR$(27);"[@";CHR$(4);CHR$(0);CHR$(0);CHR$(0);
CHR$(34);CHR$(0)
Notes, which contain important information that you should read, are set in italics.
For example:
Note: If you send a location value outside the set left or right margin, this command
will be ignored.
viii
ML320T, ML321T
ML390T, ML391T
How to Use this Manual
ML520, ML521
ML590, ML591