Hyundai IONIQ 6 2023 Owner's Manual page 36

Introduction/Getting Started with Your Electric Vehicle
• If an error occurs, you can reset the portable charger by disconnecting and
reconnecting the power plug, and then pressing the button on the control box for more
than two seconds.
• If the same symptom repeats after resetting the portable charger, have the vehicle
inspected by an authorized HYUNDAI dealer.
• If there is no status change for more than one minute, the portable charger will be
switched to power saving mode, and the display light will be turned off.
Charging with a portable charger
Follow the instructions below to charge the vehicle with a portable charger.
1. Connect the power plug of the portable charger to the electrical outlet at tour home.
• The power indicator light on the control box will turn green.
2. Set the charging current by pressing the button on the back of the control box for more
than two seconds until the number on the charging current indicator blinks.
NOTICE
An example of a portable charger charging current setting suitable for the rated current
of the power supplied is as follows. However, the appropriate charging current may
vary depending on the environment, such as the power usage inside the building.
Outlet Current
14-16 A
12-13 A
10-11 A
8-9 A
• The charging current is changed each time the button is pressed, in the order of "6 A
- 8 A - 10 A - 12 A."
• If 10 seconds have passed without pressing any button, the blinking will stop and the
charging current will be finished.
3. With the vehicle started, apply the Electronic Parking Brake (EPB) while pressing the
brake pedal.
4. Turn all switches off, shift to P (Park), and stop the vehicle.
5. With the vehicle door unlocked, press the open indicator on the charging door to open
the charging door.
6.Open the charging inlet cover and check the charging connector and charging inlet for
dust or other contaminants.
• If there is any dirt or contaminants, remove it using the air gun.
1-30
ICCB Charge level
12 A
10 A
8 A
6 A