Eversys Cameo C'2c/Classic User Manual page 9

For Your Safety
RISK OF ELECTROCUTION
The power plug is the device used for disconnection in case of problems or emergency
and it must be easily accessible at all times.
Only use the power cord provided with the machine.
Never use a machine which is damaged or has a defective power cord. With signs
of damage, for example if there is a smell of burning or visible insulation damage,
unplug the machine, immediately stop using it and contact your local service
organisation.
The power cord must only be repaired by a service organisation appointed by the
manufacturer.
Make sure that the cable is not near a hot surface.
Be careful to ensure that the power cord is not trapped and does not rub against
sharp edges.
Repair, commissioning and service operations must only be performed by a service
organisation appointed by the manufacturer.
Never open the machine, nor remove any parts except for the instructions specified
in manuals (e.g. User Manual).
Only connect the machine to the electrical power sources specified and a power
supply network provided with a protective earth.
Requirement for Australian deviation: disconnection incorporated in the fixed wiring
is in accordance with AS/NZS 3000.
Do not immerse the appliance in water.
RISK OF BURNS OR SCALDING
The hot water, steam, milk and coffee dispensed are hot. Avoid direct contact with
the skin.
Always place a suitable cup under the outlet before dispensing products.
During automatic cleaning, hot cleaning solution and steam are released several
times.
Keep hands and skin away from the outlets.
HOT SURFACE
The cup warmer panel could reach 90 °C, contact may cause burns in less than a
second.
02.01.2023 Page 9 of 150 © Eversys S.A.