Installation Procedure; Configuration Of A Minimal System For Using The Speed Dome - urmet domus 1093 Installation And Instruction Manual

4

INSTALLATION PROCEDURE

This section provides detailed instructions for installing the Urmet speed dome 1093/655M2. These instructions assume
that the installer has a good knowledge of installation techniques and is capable of adopting safe installation methods.
4.1

CONFIGURATION OF A MINIMAL SYSTEM FOR USING THE SPEED DOME

The 1093/655M2 cameras contain a built-in receiver that decodes the commands arriving from the control panel or the
system keyboards. To function properly there must be at least one control panel. In addition to configuring operating
parameters, the keypad is used to manage horizontal axis (360° continuous) and vertical axis (180°) panning and tilting,
motorised zooming, recalling and programming of the preset sequences.
Important note
Configuring the speed dome parameters in advance (protocol, address, baud rate, termination resistance) (Also
see the dedicated part of this manual).
A switch for performing maintenance operations on the speed dome must be included.
 Please check a 120 Ω resistor is mounted on both RS-485 terminals.
Wall-mounted
Identify the camera installation point and proceed as follows:
 Include a connection box for making connections and fitting the power unit, if required.
 Drill holes according to the type of wall (cement, wood, etc.) and the fastening devices used.
 If the type of installation includes laying of cables in sight, unscrew the plug on the lower part of the bracket with
a slot type screwdriver and insert all the functioning cable of the dome inside the bracket, providing a suitable
protection conduit for the cables.
 Insert the connection cables (power-video-data) inside of the bracket until they exit from the opposite side.
 Fasten the bracket to the speed dome screwing the 3 screws at the end of the bracket.
 Fasten the bracket to the wall.
 Connect the RJ45 cable for the TCP/IP network connection.
 Connect RS485 Yellow/Orange cable to the control keyboard.
 Connect the Yellow/Green cable to ground outlet.
 Connect the power cable jack to the PSU supplied
To connect the Easy Dome IP on the IP network, refer to the appendix at the end of the manual: IP interface
configuration
DS1093-530