Function Programming Menu - urmet domus 1093 Installation And Instruction Manual

The presettings are saved in a permanent memory area of the speed dome where they are maintained also when power
is disconnected. However, restoring default settings, which can be activated with CLEAR MEMORY, (see SYSTEM
SETUP menu) will delete all preset values.
Caution. The presettings store the coordinates according to an angular reference system. Therefore, the reference
system zero point may become misaligned with the speed dome mechanics after prolonged use of the tilting and panning
functions. Minor inaccuracies in preset positions may occur. In this case, calibrate the angular coordinate system using
the { DOME RESTART } command in the SYSTEM SETUP menu. This calibration is automatically run when the speed
dome is switched on.

12 FUNCTION PROGRAMMING MENU

Use the following command from the control panel to access the function programming menu.
95 + SHOT (1092/621)
At this point, if no password is required for access, the following first level menu will appear on the screen:
Otherwise, if a password is required, the operator must be authorised by using the Administrator's password.
To scroll the items in the menu, just move the joystick vertically and position the cursor in correspondence to the menu
item to be selected: then use the command OPEN (1092/621) or IRIS+ (1092/693) (indicated as IRIS + in the
menus) or move the joystick rightward to enter the second level menu selected.
Once you've entered, to return to the previous level menu, just use the CLOSE (1092/621) or IRIS-(1092/693)
commands (indicated as IRIS - in the menu).
If you want to exit definitively any level menus simply use the CLOSE (1092/621) or IRIS- (1092/693)
commands.
Important note
The OSD menu of the camera, if not used, will go in to time-out mode after 30".
DS1093-530
or SHOT + 95 (+ ENTER) (1092/693)
SPEED DOME
1093/655M2
3 Display Options
4 Control Options
6 Function Program
7 System Setup
8 Exit