Opening The Box; Installation Procedure - urmet domus 1092/605 Quick Manual

Easy dome camera ahd 10x with ir illuminator

Table of Contents

Available languages

OPENING THE BOX

Check that the packing and the contents are not visibly damaged. Contact the retailer immediately if parts are either

missing or damaged. Do not attempt to use the device in this case. Send the product back in its original packing if it is

damaged.

4.1

CONTENTS OF THE BOX

N°1 Easy Dome 10X with IR LED

N° 1 Power supply

N° 1 Wall bracket

N°1 User manual

IMPORTANT NOTE

Accessories may be changed without prior notice.

This section contain detailed instructions for installing Urmet Domus 1092/605. These instructions assume that the

installer has a good knowledge of installation techniques and is capable of adopting safe installation methods.

5.1

EASY DOME MINIMUM CONFIGURATION

The Easy Dome camera contains a built-in receiver that decodes the controls from the control keypad. At least one

keypad is therefore needed to control the camera. In addition to configuring operating parameters, the keypad is used to

manage horizontal axis (360° continuous) and vertical axis (180°) panning and tilting, motorised zooming, recalling and

programming the Easy Dome preset sequences.

The following sections show how to use these adapters.

Please check a 120 Ω resistor is mounted on both RS-485 terminals.

LBT 20137B

Table of Contents

1092