Advertisement
Available languages
Available languages
3
INSTALLATION
It is advisable to proceed as follows for correct camera installation and configuration:
1.
Make sure that no units are powered before starting the installation procedure.
2.
It is advisable to install and configure one camera at a time if you are installing multiple
cameras on the same network.
3.
Connect the camera to the network (see section 4). It is advisable to check that the WiFi
signal received by the camera is higher than or equal to 60.
4.
Position the camera in a point on the wall or other surface and adjust the bracket to frame
the required scene.
5.
If you want the camera to record and store video files on a micro SD card (not included),
plug the card into the slot when the camera is powered off (sse the picture below). Power
on the camera and use the camera's wepgabe or the app to format the card before starting
the recording function.
If you are using a NVR/HVR device, assign a static IP address to the camera and use the
6.
NVR/HVR menu to add the camera to a recording channel.
4
HOW TO CONFIGURE THE CAMERA IN A NETWORK
In this section explanation is provided to configure the camera in the network and to connect it
remotely from the smartphone App or from a PC.
IMPORTANT NOTE: the camera is provided with two different network boards, one for the wire
connection and one for the WiFi connection, each with its own MAC address and is own IP
address.
4.1
HOW TO ADD THE CAMERA TO A WIFI NETWORK FROM THE APP
The camera can be quickly configured on the WiFi network using a smartphone, to do so refer
to the paper Quick Guide of the Urmet App V-Stream provided with the product.
DS1099-008A
9
Advertisement
