Every 800 Hours; Adjusting Engine Valve Clearance; Every 1000 Hours Or 1 Year; Replacing Air Cleaner Primary Element And Secondary Element - Kubota LX2610 Operator's Manual

EVERY 800 HOURS

6. Properly dispose of used oil.
Oil capacity
(1) Filling plug with dipstick
(2) Drain plug
EVERY 800 HOURS

1. Adjusting engine valve clearance

Consult your local KUBOTA Dealer for this service.

EVERY 1000 HOURS OR 1 YEAR

Be sure to do the following servicing once every 1000
hours or yearly, whichever comes first.
1. Replacing air cleaner primary
element and secondary element
(See Cleaning air cleaner primary element on page
120.)
NOTE :
• To prevent serious damage to the engine, use
only a KUBOTA genuine filter.

EVERY 1500 HOURS

1. Cleaning fuel injector nozzle
injection pressure
Consult your local KUBOTA Dealer for this service.

2. Checking EGR cooler [LX3310]

Consult your local KUBOTA Dealer for this service.
EVERY 2000 HOURS OR 2
YEARS
Be sure to do the following servicing once every 2000
hours or biennially, whichever comes first.
LX2610,LX3310
4.7 L (5.0 U.S.qts.)
(A) Oil level is acceptable within
this range.
1. Flushing cooling system and
changing coolant
WARNING
To avoid personal injury or death:
• Do not remove the radiator cap while the
coolant is hot. When cool, slowly rotate the cap
to the first stop and allow sufficient time for
excess pressure to escape before removing the
cap completely.
1. Stop the engine, remove the key and let it cool
down.
2. To drain the coolant:
• [LX2610]
Open the radiator drain shutoff-valve, and then
remove the radiator drain plug and the radiator
cap.
• [LX3310]
Remove the radiator hose clamp, and then
remove the radiator hose and the radiator cap.
3. After the coolant has drained:
• [LX2610]
Close the drain shutoff-valve and reinstall the
drain plug.
• [LX3310]
Reinstall the radiator hose, clamp, and drain
plug.
4. Fill with clean soft water and cooling system
cleaner.
5. Follow the directions
instruction.
6. After flushing, fill with clean soft water and anti-
freeze until the coolant level is just below the
radiator cap.
Install the radiator cap securely.
7. Fill with coolant up to the [FULL] mark of the
recovery tank.
8. Start up and operate the engine for a few minutes.
9. Stop the engine, remove the key and let it cool
down.
10. Check the coolant level of the recovery tank and
add coolant if necessary.
PERIODIC SERVICE
given in the cleaner
131